 A113 Post Assembly Activator (200ml)
 Accelerator is used for the fast curing of Cyanoacrylates, depositing a correct balance of neutralising ions on the surface, stimulating attraction for the adhesive and preparing the surface for bonding.
Excellerator© prevents absorption of the lower viscosity superglues into porous items. Excellerator© helps bridge gaps which decreases polymerisation time. |
A387 Structural Acrylic Activator (50ml)
Activator A387 must be used with each of the grades mentioned as it is an essential part B of the cure system of each of the specified products. Apply adhesive on one side and Activator to the other for porous surfaces.
A light layer can be applied to both surfaces and adhesive can be applied to either and the bond made immediately.
Bonds form in less than 5 minutes @ 20ºC. A faster A386 version is also available.. |
A471 Structural Activator for Anaerobics (200 ml)
Speeds Cure of all Anaerobic fluids and pastes and extends cure through volume.
A471 helps fixture time and reduces ultimate cure time.
Use when materials are inactive (plastics or passivated metals) or where temperature is under 15C. |
A649 Structural Activator for Anaerobics (50 ml)
Activator A649 must be used with each of the grades mentioned as it is an essential part B of the cure system of each of the specified products. Apply adhesive to either one or both sides (for faster cure) and adhesive to one side once the Activator has dried and make the bond immediately without allowing movement during fixture time. |
A701 Primer for Pollyolefins / Cyanoacrylates (50ml)
Command Cure Primer is a new surface modifier overcoming the difficulties often experienced with exotic plastics, thermoplastics, elastomers, olefins and silicones.
Curing on demand, command cure will overcome the most difficult low energy surfaces. It is simple to apply and can be brushed or sprayed onto clean surfaces.
APPLICATIONS
* Silicone cord, sheet, profiles, moulded parts.
* Santoprene Cord, sheet, profiles, moulded parts.
* E.P.D.M Elastomers, Sheet, profiles.
* Exotic Plastics, suryn, etc.
* Polyolefins (Teflon’s).
* Polypropylen/blends (PP).
* Polyethylene/blends (PE).
* Polytetrafuoryl Ethylene (acceptable). |
Shift-A-Gasket (400ml)
Gasket Remover & Cleaner
Dissolves all types of anaerobics, silicones, polyurethanes, old gasket sealants, cleans & degreases.
A blend of highly active solvents suitable for the removal of most paints and varnishes from a variety of surfaces including wood, metal, ceramics etc. The blended wax seal prevents excessive solvent loss allowing for longer dwell time for maximum penetration of hardened resins and gaskets.
For use as an all purpose Gasket Remover on flanges, cylinder heads, pumps and all types of assembly.
Tough carbon deposits can be removed as well as paints, varnishes and graffiti. Protect surfaces you do not wish to damage as blistering will occur on paint finishes etc.
 |
| |
Disclaimer
Archer Engineering and Holdtite are not responsible for results obtained in the use of the products by any person whose methods are beyond its control. It is your responsibility to determine the suitability of any of the products and methods of use or preparation. It is also your responsibility to observe and adopt such precautions as may be advisable for the protection of personnel and property in the handling and use of any Holdtite products. In no event shall Holdtite or Archer Engineering be liable to you or any third party under law for any loss or damage (including but not limited to direct, indirect, economic and consequential damage) in respect of any matter whatsoever related to any information in this website. |
|
