 R41 RETAINER COMPOUND (TDS 23)
BEARING FIT-Yellow
 Medium strength easily removable compound.
Securing all types and sizes of bearings, shafts, cylindrical parts allowing disassembly when required.
When cure speed is long acceptable bond time can be obtained by treating parts with A471 Activator or by using the faster A649 Accelerator.
Temp. Range -55 o C to + 150 o C
Structural activators/Primers can result in up to 30% strength loss.
|
R62 RETAINER COMPOUND (TDS 24)
HIGH TEMP RETAINER
 Retainer is rated up to 232 o C as the upper operational temperature. R62 is
designed for bonding/securing in a high strength manner, all types of cylindrically
fitted parts.
Used on all types of applications where temperatures exceed the design features of conventional Retainers, above 150 o C . R62 develops High Strength at elevated temperatures.
Speed cure R62 by applying a localised heat with a heat gun or by placing parts in an oven @ 100 o C for 30 minutes. Pre-heating of parts also accelerates the fixture and ultimate final cure.
If required, apply Primer A471 or the faster A649 Accelerator.
Structural activators/Primers can result in up to 30% strength loss. |
R68 RETAINER COMPOUND (TDS 142)
EXTRA HIGH STRENGTH
High Strength retention for cylindrical parts under dynamic load/stresses, keys, splines, gears etc.
Fatigue resistant under heavy loads.
If required, apply Primer A471 or the faster A649 Accelerator.
Temp. Range -55 o C to + 150 o C
Structural activators/Primers can result in up to 30% strength loss.
|
| |
Disclaimer
Archer Engineering and Holdtite are not responsible for results obtained in the use of the products by any person whose methods are beyond its control. It is your responsibility to determine the suitability of any of the products and methods of use or preparation. It is also your responsibility to observe and adopt such precautions as may be advisable for the protection of personnel and property in the handling and use of any Holdtite products. In no event shall Holdtite or Archer Engineering be liable to you or any third party under law for any loss or damage (including but not limited to direct, indirect, economic and consequential damage) in respect of any matter whatsoever related to any information in this website. |
|
